Wheel Hub Holding Tool - RX2110 - Laser Tools
The 7090 is designed to bolt to a wheel hub or drive flange to allow centre hub nuts or flange nuts to be loosened or tightened. Provided with a ½” drive hole to allow use of an additional power bar or torque wrench if required
Designed for use on vehicles with 4 stud, 5 stud, 6 stud and 8 stud patterns flanges and hubs where access permits
Applications include: Wheel hubs, drive flanges, gear box output drive flanges, differential input and output flanges
Non-slip plastic dipped handle.
Can also be used to hold rear differential yokes on solid axle vehicles during bearing service.
Can also be used with a ½” drive power bar or Torque wrench. Remember to make allowance for the additional length of the tool.
Holding a wheel hub steady when working on a drive shaft is one of these jobs that require a third hand. But not with this wheel hub holding tool from Laser (part number 7090). Simply bolt it across a couple of wheel studs or bolts and it holds the hub steady while the axle nut is removed.
Designed for use on vehicles with 4 stud, 5 stud, 6 stud and 8 stud patterns and also lets you hold the hub and drive shaft steady while torqueing up the shaft securing screws. Can also be used to hold rear differential yokes on solid axle vehicles during bearing service.