Knuckle Joint - Lower - Redesigned - Pair - RGG001219P1

Knuckle Joint - Lower - Redesigned - Pair - RGG001219P1
Knuckle joint assembly with superior aluminium housing (anodised red), greatly exceeding the quality of the original plastic version. The ball and cup design, with a grease nipple, allows maintenance and therefore prolongs the life without having to dismantle. The pin and cup are case hardened to a depth of 0.5mm for long life. Inevitability if you try and remove an old knuckle the plastic housing is brittle and will shatter, this new aluminium design prevents this.

The top arm needs to be drilled and tapped with a M6 thread to allow the grease nipple to be screwed in for scheduled greasing and then removed and replaced with the M6 blanking screw. The grease nipple cannot be left in as it will hit the bump stop and snap. One nipple is supplied for two knuckles.

Please note: Due to the difference in tolerances between the factory MG Rover arms, a small amount of machining may be required to fit these.