Triumph Herald Camshaft and Distributor Drive

Order your Triumph Herald Camshaft and Distributor Drive ⛽ Low prices and fast, worldwide delivery ✈ British car experts ♚ Call ☎ 01522 568000 or ☎ 1-855-746-2767
Part No.: GRID005165

Prices displayed in:
Camshaft runs directly in 'original' cylinder block - does not require cam bearing set
Camshaft runs directly in 'original' cylinder block - does not require cam bearing set
Camshaft runs directly in (original) cylinder block. Does not require bearing set.
£123.00 ex VAT£147.60 inc UK VAT
Quantity
  • Timing: Inlet 30-70 Exhaust 70-30
  • Duration: 280°
  • Lift: 0.270”
  • Installation Figure 108°
  • Valve Clearnces: Inlet 0.014” Exhaust 0.015”
This profile is best used with Webers and is recommended for a more "open road" application, where the engine is allowed to 'Rev' more. It will produce 105/110 BHP at 5,500 RPM, but allow for a loss of low speed torque with improved power from 2,900 RPM upwards.

Please Note: This camshaft is ground by Kent Cams but to an exclusive bespoke profile that they do not catalogue.
£265.00 ex VAT£318.00 inc UK VAT
Quantity
Camshaft runs directly in (original) cylinder block. Does not require bearing set.

1 Camshaft Recon - Part No. RKC3305R
£105.00 ex VAT£126.00 inc UK VAT
£75.00 ex VAT£90.00 inc UK VAT
Quantity
It is vital that a camshaft & its followers are properly lubricated when installed and run in an engine for the first time.

Use ‘Cam Lube’ (RX1358).

This is the smaller diameter follower at .687" OD.
£9.55 ex VAT£11.46 inc UK VAT
Quantity
It is vital that a camshaft & its followers are properly lubricated when installed
and run in an engine for the first time.
Use ‘Cam Lube’ (RX1358)

This is the larger diameter follower at 800" OD.
£3.30 ex VAT£3.96 inc UK VAT
Quantity
These Tappet/Cam Followers are Tuftride Hardened and have an oil drain hole in the side.

It is vital that a camshaft & its followers are properly lubricated when installed and run in an engine for the first time.
Use ‘Cam Lube’ (RX1358).
£6.50 ex VAT£7.80 inc UK VAT
Quantity
These Tappet/Cam Followers are Tuftride Hardened and have an oil drain hole in the side.

It is vital that a camshaft & its followers are properly lubricated when installed and run in an engine for the first time.
Use ‘Cam Lube’ (RX1358).
£48.00 ex VAT£57.60 inc UK VAT
Quantity
Note: Refer to the factory workshop manual for details on using these gaskets as shims to set gear & float.
£1.00 ex VAT£1.20 inc UK VAT
Quantity
Customer Comments
"Really impressed with online chat - located part I needed in minutes thanks!!!" Customer Comment
Product Description

Triumph Herald Camshaft and Distributor Drive