Prices displayed in: GB Pound Euro US Dollar AUD NZD
Soft Top Front Seat Belt Bar for 3 or 4 Point Inertia Seat Belt

The soft top front seat belt bar is designed to allow for easy fitting of 3 or 4 point inertia seat belts that no longer have a high mounting point available, especially if you have converted from a hard top to a soft top.

To install, simply locate the outer flat plates onto the top body capping as shown in images below and line up the rear bar with the side capping point. Drill and bolt into place either side to create a top mounting.

If you require a new seat belt you will need a 4 door front inertia belt to do this job properly and NOT a 2 door belt. The brackets you require are correct on the 4 door inertia belt. Exmoor part no.EXT001-8 =LH or EXT001-7=RH

The inertia reel mounts to the lower point and shown with the top buckle above.

This is a great kit and offers a very easy way to convert seat belts safely when modifying your vehicle without the need to install a roll bar if not required (fitting time for bar is about 30 min).

Please note that the horizontal bar may interfere with the positioning of the spare wheel behind the bulkhead if fitted. You may need to pack the spare wheel out or change its location.
-
In stock
Most orders placed now ship tomorrow!
£161.72 ex VAT£194.06 inc UK VAT
Quantity
Fits all forward facing seats only. All models.

4 point rally harness Land Rover seat belt.

This product has been tested and approved - United Nations ECU Regulation 16

**For adult use only, not suitable for children**

The 4 Point Black Harness from Exmoor Trim is available in either Black or Red webbings.

The harness has been designed specifically for Land Rover use with the two rear straps able to adjust to fit a bulkhead or the floor.

These have been fully tested and homologated for use with Land Rovers. The harness has two stylish gel badges sewn in and offers wide pad strap areas, the harness is supplied with a full fitting kit for most applications.

These are heavy duty and designed to take some punishment.
-
Usually in stock at our supplier, allow 13 weeks for delivery.
£75.94 ex VAT£91.13 inc UK VAT
Quantity
The new 4 POINT RED HARNESS from exmoor trim is available with either Black or Red webbings.The harness has been designed specifically for Land Rover use with the two rear straps able to adjust to fit a Bulkhead or Floor.

These have been fully tested and homologated for use with Land Rovers and have a stylish gel badges sewn in and good wide pad strap areas where you need them most, the harness is supplied with a full fitting kit for most applications.

These are heavy duty and designed to take some punishment.

Fits All Forward Facing Seats Only. All Models.
-
Usually in stock at our supplier, allow 13 weeks for delivery.
£75.94 ex VAT£91.13 inc UK VAT
Quantity
Suitable for:
All Land Rover 110/130 Models
(forward facing)

Buckle connection: Type
Buckle connection: Length
Webbing Length:
End bracket to End Bracket
Part No.
adjustable webbing buckle
adjustable webbing
up to 47cm
217cm
200

Fits left or right hand side
Static Lap & Diagonal  Belt

200

Total Length up to 217cm excluding buckle
Buckle on Webbing 45cm

2"/47mm wide Static lap & diagonal belt.
Belt length adjusted manually to suit occupant.
Buckle length adjusted on installation.
Typically for rear of vehicle.
-
In stock
Most orders placed now ship tomorrow!
£19.50 ex VAT£23.40 inc UK VAT
Quantity
Suitable for:
All Land Rover 110/130 Models
(forward facing)

Buckle connection: Type
Buckle connection: Length
Webbing Length:
End bracket to End Bracket
Part No.
adjustable webbing buckle
adjustable webbing
up to 47cm
217cm
200

Fits left or right hand side
Static Lap & Diagonal  Belt

200

Total Length up to 217cm excluding buckle
Buckle on Webbing 45cm

2"/47mm wide static lap & diagonal belt.
Belt length adjusted manually to suit occupant.
Buckle length adjusted on installation.
Typically for rear of vehicle.
-
In stock
Most orders placed now ship tomorrow!
£33.00 ex VAT£39.60 inc UK VAT
Quantity
Front 4 Door Inertia Reel and Buckle Seat Belt - RH

This belt will fit all Series 2 and 3 109 inch and all Defender 110 inch hard tops.

Exmoor Trim offers an exclusive range of seat belts, specifically designed to fit your Land Rover using OEM parts only.
They won't supply any other belt that isn't type approved.

Safety matters...
-
In stock
Most orders placed now ship tomorrow!
£57.21 ex VAT£68.65 inc UK VAT
Quantity
Front 4 Door Inertia Reel and Buckle Seat Belt - LH

This belt will fit all Series 2 and 3 109 inch and all Defender 110 inch hard tops.

Exmoor Trim offers an exclusive range of seat belts, specifically designed to fit your Land Rover using OEM parts only.
They won't supply any other belt that isn't type approved.

Safety matters...
-
In stock
Most orders placed now ship tomorrow!
£57.21 ex VAT£68.65 inc UK VAT
Quantity
4 Point Inertia Belt

Left or Right Hand - universal fit for the 2nd row or forward facing fold up seats, if you are using these belts for the forward facing rear seats then you may require the top mounting brackets.

Buckle section of belt attaches to the floor with a clip system so it can be easily removed.
Supplied with butterfly floor mounting clip.

Exmoor Trim offers an exclusive range of seat belts, specifically designed to fit your Land Rover using OEM parts only. They won't supply any other belt that isn't type approved.

Safety matters...
-
In stock
Most orders placed now ship tomorrow!
£58.09 ex VAT£69.71 inc UK VAT
Quantity
Customer Comments
"Fantastic service as always! I don't shop anywhere else!" Customer Comment
Product Description

Series 2 and 3 Seat Belts